When and how do I replace the anti-scale cartridge or the anti-scale granules?

There are 2 anti-scale systems for Laurastar products which vary by models: anti-scale cartridges and anti-scale granules for anti-scale water filters.
 

1) If you own a Laurastar ironing system Laurastar Smart

Anti-scale filter should be replaced when it turns completely brown. To replace it,  take out the cold water tank, remove the filter, place the new filter in the water tank and fill it with cold water up to the MAX level.
 

rtaimage-2-.jpg

2) If you own a Laurastar ironing system (such as Laurastar S4a, Laurastar S5a, Laurastar S6a, Laurastar S7a or Laurastar Pulse, Laurastar S, Laurastar S PLUS, Laurastar S Xtra ):

Anti-scale granules for anti-scale water filter should be replaced when they turn completely brown. To replace them, take out the cold water tank and remove the filter. Take off the lower section and throw the used granules in the bin. Clean the filter thoroughly then refill the lower section with a new whole sachet of granules and replace the cover. Reattach the lower part from below. Put back the filter in the water tank and fill it with cold water up to the MAX level. Then place the water tank back in its holder.
Anti-scale granules refills can be purchased on Laurastar’s online store and in selected Laurastar partner stores.

rtaimage-3-.jpg

3) If you own a Laurastar ironing system Laurastar Go or Laurastar Go +:

Use the external filter which allows you to filter tap water before it is used for ironing. Anti-scale granules for anti-scale water filter should be replaced when they turn completely brown. Remove the filter part, lift the lid and throw the the used granules in the bin. Clean thoroughly the filter, fill it up with a new anti-scale granule refill and place the lid back on. Put back the filter and fill it with cold water up to the MAX level.
Anti-scale granules refills can be purchased on by clicking here-s and in selected Laurastar partner stores.

rtaimage-4-.jpg

4) If you own a Laurastar steam generator Laurastar Lift, Lift Xtra or Laurastar Lift +:

The anti-scale cartridge should be replaced when the red indicator light for the cartridge is turned on and a warning tone sounds.
Lift the cover of the water tank and remove the water tank by pulling on its cover. Empty out the water and remove the used anti-scale cartridge. Insert a new anti-scale cartridge and fill the water tank with tap water. Finally, validate the change by pressing the change cartridge switch.
Anti-scale cartridges can be purchased on Laurastar’s online store and in selected Laurastar partner stores.

rtaimage-5-.jpg